The turbine or the analysis device has an optical defect - can I still carry out further measurements?

• Related Articles

• The turbine can no longer be loosened/is anchored - how should I proceed?

  It is important to slightly moisten the turbine before installation and remove it again immediately after the measurement. If you can no longer loosen the turbine, try to carefully apply liquid between the turbine and the breathing unit and leave it ...

• How do I clean the turbine?

  Cleaning instructions for the turbine The following classification: non-critical medical device Simple disinfection is sufficient for non-critical medical devices. The product does not need to be sterilized. The exact description of how to disinfect ...

• The basal metabolic rate measured in the Food analysis is 0kcal or less than 700kcal - what is the correct interpretation of the result?

  Food analysis: basal metabolic rate values less than 700kcal "The basal metabolic rate value in the customer's analysis is extremely low and not plausible." The most common reason for such measurements is an incorrectly used turbine. Where you able ...

• High fat percentage as a result of the Food analysis - what is the correct interpretation here?

  Measurements with 85% fat metabolism (i.e. "0% KH") will always appear from time to time and are usually plausible. These evaluations are due to a very low respiratory quotient. At this point there is a fat metabolism dominance. The body draws most ...

• uVida Activity: How does this analysis work?

  The uVida Activity analysis takes place on the treadmill or cycle ergometer. The uVida partner guides you through a step protocol, which means you start at a certain intensity and it is increased every 3 minutes until you say that you are “full ...